ADICON Support Forum Applied Digital, Inc.
Page 1 of 1 1
Topic Options
#9077 - 03/04/03 11:47 AM Install first Ocelot
Glenn Bell Offline

Registered: 03/03/03
Posts: 1
Loc: Honolulu, Hawaii
I have installed a Home Automation (HAI) controller with a HomeTouch,Inc (Grafik Touch) touch screen system. I am trying to tie the Ocelot into the system and learn IR commands. I am connected to the Dell computer which runs the Grafik Touch program, however I continue to get an error message saying to check my RS-232 cable connections and to confirm my comm port selection in the control program.

I have done all that and rebooted the whole thing with the same error message. Does anyone have any suggestions?

QUESTION: The little four prong power connector which plugs into the front of the Ocelot has a two wire connection to two of the four pins (the two on the right looking at the Ocelot head on). Is it possible I should move those two wires over to the two pins on the left? Would it blow out the Ocelot applying power to those two pins?
Glenn Bell
American Industries corp.

#9078 - 03/04/03 11:51 AM Re: Install first Ocelot
Guy Lavoie Administrator Offline
Beyond All Hope

Registered: 12/21/02
Posts: 6548
Loc: Montreal, QC, Canada
No, don't move the power connector wires over... you will possibly blow the RS-485 chip if you do that.

Have you tried accessing the Ocelot with C-Max first (even if you don't plan on using C-Max over the long run)? Use the CD that came with the Ocelot to install C-Max and test it this way first.
"If you don't know what you're doing, do it neatly..."

Page 1 of 1 1

Moderator:  Dan Smith, Monte G, ADI Tech Support, Guy Lavoie 
Hop to:
Who's Online
0 registered and 3 anonymous users online.
Recent Posts
Shout Box

Newest Members
brigiel, vevevie, zhutree, 416, saiqul
3003 Registered Users
Forum Stats
3003 Members
19 Forums
4006 Topics
23465 Posts

Max Online: 132 @ 11/13/16 10:07 AM
Su M Tu W Th F Sa
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31