Anyone ever get an SW10 working with the Ocelot?

I am not an X10 guy at all, but I need to get this working for a customer.

Below is a copy/paste from a guy controlling an SW10 with ActiveHome Pro, if someone could help with how to program this in CMAX I would greatly appreciate it \:\)

**********
I'm controlling 11 blinds (via SW10 modules) via extended code type 0. Everything goes fine, I can position the blinds quite reliably.
I'm using command bytes
- "0x03" to position any individual blind (with data byte value ranging from 0x00 to 0x19)
- "0x04" to fully open all blinds (value of the data byte not relevant)
- "0x0b" to fully close all blinds (same)
**********

Thanks,
Bruce