|
Hi!
I get the line: "X10 Activity 18:12:26 - G/1" about every minute in the X10-Monitor of my C-Max Software, even if I disconnect the CM10 from power and the only connected cables are the serial cable and the bus-cable to the SECUs.
Where does the continuous X10 activity come from?
I also have another problem with my ocelot and a Marmitek Powermid XL. It (however) disturbes the incomming X10 signals from the CM10 to the ocelot.
Except of the G/1-activity, mentioned above, everything works fine without the Powermid plugged in. I use an Easytouch35 and a V572AE to get the X10-Signal from my remote to the Ocelot. The X10-Monitor says:
O/11
O/off
As soon as I connect the Powermid to power and place it in front of the Ocelot IR-eye, the X10-Signal from my remote doesnt reach the ocelot or misses the number.
X10-Monitor most time I press a button:
G/1
and sometimes (very rare):
O/off
Does anyone have an idea what to to?
;-)
fagor
| 
