The full icons can be used on a 2 high x 1 wide button
configured as a toggle, while the half button pairs are meant to be used in a situation where you want to provide seperate on and off buttons; each one using the small single-square touch buttons. Because icons can be switched under program control, these provide a handy way of indicating status too, even if the switch is turned on or off by another signal source. For this reason, it would be best to use these icons with code of the type:

IF X10 Status/Cmnd Pair...Turns ON
THEN Set Displayed Icon... upper half on
THEN Set Displayed Icon... lower half on
IF X10 Status/Cmnd Pair...Turns OFF
THEN Set Displayed Icon... upper half off
THEN Set Displayed Icon... lower half off

Make sure you check the "hidden border" box for proper display.

http://www.appdigusers.com/ADI_2/LeoIcons/top_on.bmp


http://www.appdigusers.com/ADI_2/LeoIcons/top_off.bmp


http://www.appdigusers.com/ADI_2/LeoIcons/bottom_on.bmp


http://www.appdigusers.com/ADI_2/LeoIcons/bottom_off.bmp


http://www.appdigusers.com/ADI_2/LeoIcons/full_switch_on.bmp


http://www.appdigusers.com/ADI_2/LeoIcons/full_switch_off.bmp